Quantcast USE OF THREAD ADHESIVE

 

Click here to make tpub.com your Home Page

Page Title: USE OF THREAD ADHESIVE
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
INSPECTION INSTRUCTIONS
Up
TB-9-2320-279-13-P-2 Concrete Protection Kit for M977 Series Heavy Expanded Mobility Tactical Trucks (HEMTT) Manual
Next
DOOR HANDLE ASSEMBLY REPLACEMENT - TB-9-2320-279-13-P-20057
TB 9-2320-279-13&P-2
GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
0011 00
USE OF THREAD ADHESIVE
WARNING
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause lung irritation.
Contact with skin can cause dermatitis. Wear gloves and safety goggles and use product in a well-ventilated
area away from open flame. If ingested, keep individual calm and seek medical attention. DO NOT induce
vomiting. If contact with skin or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW
local policy and ordinances. Failure to follow this warning may cause injury to personnel.
1.
All nuts, bolts, and screws used in the installation of the armor kit or when replacing armor kit components must be
coated with Thread Adhesive (Item 1, WP 0035 00), unless otherwise stated.
2.
Locknuts supplied with the kit do not require thread adhesive.
USE OF SEALANT
1.
When applying sealant, follow manufacturer's instructions on label of container.
2.
Sealant should be applied in an even and continuous 1/4 inch bead along mating surfaces.
APPLYING TORQUE
1.
When tightening fasteners, use torque value as specified in Torque Limits (WP 0036 00).
2.
If a unique torque value is required, it will be provided in the procedural step of the task.
TAGGING INSTRUCTIONS
1.
Use marker tags to identify all electrical wires and any other parts that may be hard to identify or replace later. Fasten
tags to parts during removal by wrapping wire fasteners around or through parts and twisting ends together. Position tags
to be out of the way during cleaning, inspection, and repair. Mark tags with a pencil, pen, or marker.
2.
Whenever possible, identify electrical wires with the number of the terminal or wire to which it connects. If no markings
can be found, tag both wires or wire and terminal, and use the same identifying mark for both. If you cannot tag a wire
because it must fit through a small hole or you cannot reach it, write down the description of the wire and the point to
which it connects, or draw a simple diagram on paper. Be sure to write down enough information so you will be able to
properly connect the wires during assembly. If you need to identify a loose wire, look for identifying number near end of
the wire, stamped on a permanent metal tag. Compare the number to wire numbers on the appropriate electrical sche-
matic.
3.
Identify and tag other parts as required by name and installed location.
END OF WORK PACKAGE
0011 00-5/(0011 00-6 Blank)

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.