DOOR ASSEMBLY REPLACEMENT - CONTINUED
INSTALLATION - CONTINUED
Perform step 8 if strap assembly was removed from door frame.
If door frame is new, refer to Crew Protection Kit Installation Instructions (WP 0039 00) for instruc-
tions on drilling holes in frame for installation of strap assembly.
Install strap assembly (4) on door frame with two bushings (7), washer (6), bolt (5), washer (8), and new locknut (9).
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause lung irritation.
Contact with skin can cause dermatitis. Wear gloves and safety goggles and use product in a well-ventilated
area away from open flame. If ingested, keep individual calm and seek medical attention. DO NOT induce
vomiting. If contact with skin or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW
local policy and ordinances. Failure to follow this warning may cause injury to personnel.
Apply thread adhesive to bolt (2). Install strap assembly (4), washer (3), and bolt (2) on door assembly.
Adjust latch as necessary (WP 0016 00).
Verify correct operation of door assembly.
If removed, install outside mirror on door assembly (TM 9-2320-279-20).
END OF WORK PACKAGE
0015 00-5/(0015 00-6 Blank)