UPPER BRUSH GUARD REPLACEMENT - CONTINUED
REMOVAL - CONTINUED
CLEANING AND INSPECTION
Install two threaded studs into second threaded hole from each outside end of upper brush guard (15). Hand tighten
Install upper brush guard shim (18) over threaded studs.
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
Upper brush guard weighs 131 lb (59 kg).
Attach sling and lifting device to upper brush guard (15).