Quantcast CLEANING AND INSPECTION - TB-9-2320-279-13-P-20127

 

Click here to make tpub.com your Home Page

Page Title: CLEANING AND INSPECTION
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
REMOVAL - TB-9-2320-279-13-P-20126
Up
TB-9-2320-279-13-P-2 Concrete Protection Kit for M977 Series Heavy Expanded Mobility Tactical Trucks (HEMTT) Manual
Next
LEFT SIDE BLAST DEFLECTOR REPLACEMENT
TB 9-2320-279-13&P-2
RIGHT SIDE BLAST DEFLECTOR REPLACEMENT - CONTINUED
0027 00
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Side blast deflector weighs 145 lb (66 kg).
Position notch on inside edge of blast deflector in front of operator compartment support.
1.
Attach and secure lifting device under side blast deflector (11). Move side blast deflector into position under vehicle.
2.
Install four washers (2) and bolts (1) on rear of side blast deflector (11) into threaded plate in fender support. Tighten
bolts to 80 lb-ft (109 Nm).
NOTE
Bolt lengths are not the same. Ensure bolts are installed as tagged.
3.
Install three washers (10), bolts (9), washers (8), and new locknuts (7) on front of side blast deflector (11). Hand tighten
locknuts.
4.
Install three washers (6), bolts (5), washers (4), and new locknuts (3) on front of side blast deflector (11). Hand tighten
locknuts.
5.
Tighten three locknuts (3) on front of side blast deflector (11) to 280 lb-ft (380 Nm).
6.
Tighten three locknuts (7) on front of side blast deflector (11).
7.
Install center blast deflector (WP 0029 00).
8.
Install right step (TM 9-2320-279-20).
END OF WORK PACKAGE
0027 00-3/(0027 00-4 Blank)

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.
6230 Stone Rd, Unit Q Port Richey, FL 34668

Phone For Parts Inquiries: (727) 493-0744
Google +