 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TB 9-2320-279-13&P-2
REAR SIDE ARMOR REPLACEMENT - CONTINUED
0030 00
CLEANING AND INSPECTION
INSTALLATION
NOTE
Position thinner panel on vehicle first, then thicker panel.
1.
Install cab side (rear) armor (14 and 13) on left side of vehicle.
2.
Install two washers (18) and bolts (17) through cab side (rear) armor (14 and 13).
NOTE
Seat belt brackets in this procedure apply only to vehicles with a 3-point seat belt system.
3.
Install attachment plate (2), seat belt bracket (3), washer (5), and new locknut (4). Only hand tighten locknut at this time.
4.
Install attachment plate (12), seat belt bracket (11), washer (10) and new locknut (9). Only hand tighten locknut at this
time.
5.
Install handle (19), two washers (16), bolts (15), attachment plates (1 and 8), two washers (7), and new locknuts (6).
Only hand tighten locknuts at this time.
6.
Close cab door and measure gap between rear edge of door and front edge of cab side (rear) armor (13 and 14). Gap
should be between 1/8 in. (3.2 mm) and 3/8 in. (9.5 mm). Adjust position of cab side (rear) armor as necessary.
7.
Tighten locknuts (4,6, and 9) to 35 ft-lb (47.5 Nm).
END OF WORK PACKAGE
0030 00-3/(0030 00-4 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals