Install the Headlights

II106700-5

Rev. B

5.1.4 Install the Headlights

a. In order to install the Headlight Assemblies, it is necessary to identify which type of

Marker Light is used on the vehicle. Before being removed, the Marker Light was

located just inboard of the Headlight. Inspect the Marker Light and determine whether

an incandescent bulb (i.e., a common lamp bulb) is used inside the light. If an

incandescent bulb is NOT found, install the Headlight Assemblies using Steps b, c, e,

and f, as the Adapter, P/N 111442-1, is not required. If an incandescent bulb IS found,

install using Steps b through f.

b. Install the LH Headlight Bracket (P/N 111418-1) (See Figure 28) using two bolts

(3/8 16 x 1.500 LG) and four washers (3/8 ID) in the top holes. Then, install

three bolts (3/8 16 x 1.500 LG), six washers (3/8 ID), and three locknuts

(3/8 16) in the bottom holes of the Headlight Bracket.

Figure 28. Left-hand Headlight Bracket Installed.

c. Install the RH headlight bracket (P/N 111418-2) using three bolts (3/8 16 x 1.500 LG),

six washers (3/8 ID), and three locknuts (3/8 16) (See Figure 28). Hand-tighten the

locknuts. For the bottom holes, use the three bolts (3/8 16 x 1.500 LG),

six washers (3/8 ID), and three locknuts (3/8 16).

0039 00-56