GENERAL MAINTENANCE INSTRUCTIONS
THIS WORK PACKAGE COVERS
Standard Tool Requirements
Use of Thread Adhesive
Materials/Parts - Continued
Oil, Lubricating (Item 5, WP 0033 00)
Tools and Special Tools
Rag, Wiping (Item 7, WP 0033 00)
Tool Kit, General Mechanic's (Item 10, WP 0032
Tag, Marker (Item 10, WP 0033 00)
Shop Equipment, Common No. 1 (Item 8, WP 0032
Adhesive, Thread (Item 1, WP 0033 00)
Cleaning Compound, Solvent (Item 2, WP 0033 00)
Cloth, Abrasive (Item 3, WP 0033 00)
Detergent (Item 4, WP 0033 00)
These general maintenance instructions contain general shop practices and specific methods you must be familiar with
to properly install and maintain the Crew Protection Kit.
Read and understand these practices and methods before starting maintenance tasks on the armor kit.
Before starting a task, think about the risks and hazards to your safety as well as others. Wear protective gear such as
safety goggles, face shield, safety shoes and gloves. Protect yourself against injury.
Observe all WARNINGs and CAUTIONs.
When lifting heavy parts, always use assistance. Ensure lifting equipment is working properly, suitable for the task
assigned, is of sufficient load capacity, and secured against slipping.
Always use power tools carefully.
Before beginning a procedure, ensure that the following conditions have been observed, unless otherwise specified:
Vehicle must be parked on level ground with parking/emergency brake applied (TM 9-2320-364-10).
Transmission must be in N (Neutral) (TM 9-2320-364-10).
Engine must be off (TM 9-2320-364-10).
If equipped, battery disconnect switch must be in OFF position (TM 9-2320-364-10).