 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TB 9-2320-364-13&P-2
LOWER BRUSH GUARD REPLACEMENT - CONTINUED
0019 00
INSTALLATION - CONTINUED
NOTE
To assist in alignment and fit of armor plates, DO NOT fully tighten mounting hardware until all armor
plates have been installed.
6.
Install two washers (18), bolts (19), six washers (16), and new locknuts (17).
7.
Remove lifting device, sling, and two lifting links from lower brush guard (3).
8.
Install two gun mount covers (5), 12 washers (20) and new locknuts (21) to upper brush guard (6) and lower brush
guard (3).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
IED front panels weigh 60 lb (27 kg) each.
9.
With assistance, install two IED panels (13), six washers (15), new locknuts (14), eight washers (11), and bolts (12) to
lower brush guard (3).
10.
Install 15 washers (8), bolts (7), washers (9), and new locknuts (10) in bottom edge of lower brush guard (3).
6
5
21
7
20
19
18 13
8
17
16 3
15
9
14
11 10
13
12
417-022
0019 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals