 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TB 9-2320-364-13&P-2
ROOF ARMOR REPLACEMENT - CONTINUED
0023 00
REMOVAL
1.
Loosen 10 bolts (15) on two front roof brackets (14).
2.
Remove 12 locknuts (17), washers (16), and two front roof brackets (14). Discard eight locknuts.
3.
Reinstall two locknuts (17) on both stud plates (18) to keep stud plates attached to roof armor (19) during removal. Hand
tighten locknuts.
4.
Remove 20 locknuts (20), washers (21), and two spacers (13) from around the escape hatch opening. Discard locknuts.
5.
Remove eight bolts (2), washers (3), locknuts (4), and washers (5) from two antenna brackets (1). Discard locknuts.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Roof armor weighs 219 lb (99.3 kg).
6.
Attach sling and lifting device to lifting eyes (6) on roof armor (19).
7.
Using lifting device, lift roof armor (19) from cab roof and place on flat surface.
8.
Remove sling and lifting device from lifting eyes (6).
9.
Remove four locknuts (17) and two stud plates (18) from front of roof armor (19). Discard locknuts.
10.
If damaged, remove escape hatch seal (22) from roof armor (19).
11.
Remove four locknuts (23), washers (24), and stud plate (25) from roof armor (19).
12.
Remove four locknuts (9), washers (10), bolts (12), washers (11), and two storage brackets (8) from roof armor (19).
13.
If necessary, remove two lifting eyes (6) and stud plate (7) from roof armor (19).
0023 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals