CLEANING AND INSPECTION - TB-9-2320-364-13-P-20113

TB 9-2320-364-13&P-2

REAR CAB (RIGHT) ARMOR REPLACEMENT - CONTINUED

0024 00

CLEANING AND INSPECTION

Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).

INSTALLATION

CAUTION

Secure all hoses, lines, and electrical harnesses near bottom of right rear cab wall away from cab wall. Do

not allow rear cab (right) armor to rest on any hose, line, or electrical harness. Failure to follow this caution

will result in damage to vehicle.

Check installation area of rear cab (right) armor for hoses, lines, and electrical harnesses. If necessary, reposition and

secure components away from rear cab (right) armor installation area.

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-

dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-

sonnel.

NOTE

Rear cab (right) armor weighs 100 lb (46 kg).

Install lifting link, sling, and lifting device in top-center hole of right rear cab armor (15).

Use lifting device to install right rear cab armor (15) on vehicle.

Install six washers (5), bolts (6), washers (2), and new locknuts (1) on right rear cab armor (15).

NOTE

One armored washer is located on interior of cab and one armored washer is located on exterior of cab.

With assistance, install two armored washers (14), washer (10), bolt (11), washer (12) and new locknut (13) on rear of

cab.

Install bracket (7), three washers (4), bolts (3), washers (9) and new locknuts (8) on top of right rear armor (15).

Install roof armor (WP 0023 00).

Connect battery cables (TM 9-2320-364-20).

END OF WORK PACKAGE

0024 00-3/(0024 00-4 Blank)