Quantcast Figure 18. Position the Windshield Armor Frame into the cab windshield opening. - TB-9-2320-364-13-P-20262

 

Click here to make tpub.com your Home Page

Page Title: Figure 18. Position the Windshield Armor Frame into the cab windshield opening.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Figure 17. Windshield Frame pre-assembly. - TB-9-2320-364-13-P-20261
Up
TB-9-2320-364-13-P-2 Crew Protection Kit for Truck Tractor M1074/M1075 Palletized Load System (PLS) Manual
Next
Figure 19. Urethane Sealant and Ribbon Sealer vehicle locations. - TB-9-2320-364-13-P-20263
II113300-1-103
Rev. A
h) Pre-fit the Windshield Frame Assembly on the vehicle, as shown in Figure 18.
Adjust the Side and Bottom Brackets as needed to line up the studs on the
Windshield Frame. Use caution to avoid damage to the studs. DO NOT hammer the
studs into position on the brackets. Remove the Windshield Frame Assembly and
tighten the set screws in the Side and Bottom Windshield Brackets.
Figure 18. Position the Windshield Armor Frame into the cab windshield opening.
i)
To create an environmental seal between the Vehicle Cab and Windshield Frame
apply the Urethane Sealant (P/N 104302-1) and the Ribbon Sealer (P/N 104303-1)
as shown in Figure 19. If required, use additional sealant from the Front and Side
Armor Kits.
j)
Attach the Windshield Frame Assembly to the vehicle as previously done in Step (g)
using thirty-six (36) 0.250-in. self-locking nuts and thirty-six (36) 0.250-in. ID
washers. Apply light oil to the studs prior to installation of the nuts. Torque to 6 ft-lb.
k) From the inside of the cab, tighten the Set Screws on the Top Windshield Brackets
(P/N 106734-2 or -6-103).
l)
Install the "L" Brackets (P/N 106746-1-103) using the fasteners, as shown in
Figure 20. Apply light oil to the studs prior to installation of the nuts. Torque to 6 ft-lb.
0037 00-44

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.
6230 Stone Rd, Unit Q Port Richey, FL 34668

Phone For Parts Inquiries: (727) 493-0744
Google +