WINDSHIELD BALLISTIC GLASS REPLACEMENT - CONTINUED
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
Ensure all existing sealant is removed from windshield ballistic glass frame (20).
WARN I N G
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause lung irritation.
Contact with skin can cause dermatitis. Wear gloves and safety goggles and use product in a well-ventilated
area away from open flame. If ingested, keep individual calm and seek medical attention. DO NOT induce
vomiting. If contact with skin or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW
local policy and ordinances. Failure to follow this warning may cause injury to personnel.
Apply sealant to outside opening of windshield ballistic glass frame (20).
WARN I N G
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Failure to follow this warning may cause injury or death to personnel.
For proper threat protection, windshield ballistic glass must be correctly installed onto windshield bal-
listic glass frame. During installation, ensure that decal "INSTALL THIS SURFACE TOWARDS
THREAT" is located on outside of cab. Improperly installed windshield ballistic glass will not protect
occupants. Failure to follow this warning may cause injury or death to personnel.
N OT E
Windshield ballistic glass weighs 114 lb (52 kg).
With assistance, position windshield ballistic glass (19) in lower windshield ballistic glass bracket (18), with "INSTALL
THIS SURFACE TOWARDS THREAT" decal facing outside of cab.
Install top windshield ballistic glass bracket (10) on windshield ballistic glass (19) with six washers (9) and new lock-
nuts (8). DO NOT fully tighten locknuts.
Install two side windshield ballistic glass brackets (7) on windshield ballistic glass frame (19) with 10 washers (16), and
new locknuts (15).