Do not use Reverse (R) to back up truck while hook arm is
attached to flatrack or damage to LHS will occur.
Engine speed should be set at idle. However, slight
increase in engine speed may be necessary depending on
Set the transmission range selector (7) to Drive (D) and release service
brake pedal (9).
Move joystick (1) to LOAD momentarily and then to UNLOAD to let
lift-hook (10) disengage from hook-bar (8). Repeat Step (11) until hook
Move truck forward approximately 5 ft. (1.5 m).
Stop truck and set transmission range selector (7) to Neutral (N).