2-29. LOAD HANDLING SYSTEM (LHS) (CONT).
If not aligned, perform Step (8). If aligned, go to Step (9).
If not aligned:
Move joystick (1) to LOAD.
When flatrack is fully reloaded, release joystick (1).
Repeat Steps (5) through (7).
Move the joystick (1) to UNLOAD until flatrack is seated on trailer.
Release the joystick (1).
Engine speed must be at idle before using hydraulic selector
switch or damage to equipment may result.
Turn the hydraulic selector switch (2) to MAN H.A.
Move the joystick (1) to LOAD until front of flatrack is raised
approximately 12 to 18 in. (30 to 46 cm) above trailer deck height.
Turn the hydraulic selector switch (2) to MAN M.F.