|
| |
TM 9-2320-364-20-2
2-851
(1) Connect DDR cable to DDL
connector MC13.
(2) Turn ON ENGINE switch
(TM 9-2320-364-10).
(3) Select DIAG CODE display and scroll
to TPS.
(4) Slowly apply and release throttle and
read throttle position sensor (TPS)
count on reader (Para 2-11).
(5) Record count of idle and
full throttle.
(a) If count is not at 30 to 40 full
throttle or 205 to 225 at idle,
perform Step (6) below and go to
Step 4 of this Fault.
(b) If count is at 30 to 40 full
throttle or 205 to 225 at idle,
perform Step (6) below and go to
Step 2 of this Fault.
(6) Turn OFF ENGINE switch.
DDR TEST
NOTE
TPS counts and percentage are found on the
DDR ATEC DIAG CODE display.
|
