| |
TM 9-2320-364-20-3
2-2889
(1) Remove six screws and ECB side
panel.
(2) Disconnect connector MC94 from
hydraulic selector switch connector.
(3) Is there continuity on wire 1488
between connector MC94, terminal D
and connector MC83, terminal M?
(a) If there is no continuity, repair wire
1488 (see schematic Fig 2-52) or
notify DS Maintenance. Perform
Step (4) below.
(b) If there is continuity, wire 1488 is
OK.
(4) Install LHS control assembly
(Para 7-40).
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
NOTE
Connectors are removed by gently prying
up on tabs.
|