(1) Set multimeter select switch to
(2) Connect positive (+) multimeter lead
to connector MC94, terminal D.
(3) Connect negative () multimeter lead
to a known good ground.
(4) Turn ON ENGINE switch
(a) If 22 to 28 vdc are not present,
turn OFF ENGINE switch and
replace LHS control assembly
(b) If 22 to 28 vdc are present,
LHS control assembly is OK.
(5) Turn OFF ENGINE switch.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.