|
| |
TM 9-2320-364-20-3
2-2049
(1) Remove ten screws, sunshield and tilt
instrument panel.
(2) Disconnect front manifold harness
connector MC 110 from back of CTIS
controller.
(3) Disconnect rear manifold harness
connector MC 111 from back of CTIS
controller.
(4) Connect harness connector MC 111
into CTIS controller where connector
MC 110 was disconnected.
(5) Connect harness connector MC 110
into CTIS controller where connector
MC 111 was disconnected.
(6) Start engine (TM 9-2320-364-10).
(7) As assistant pushes CTIS controller
START button, listen to rear manifold for
continuous clicking.
(a) If rear manifold is clicking continu-
ously, replace CTIS controller (Para
13-7).
(b) If rear manifold is not clicking con-
tinuously, CTIS controller is OK.
(8) Turn OFF ENGINE switch.
(9) Disconnect and connect connectors
MC 110 and MC 111 to correct CTIS
controller connectors.
CTIS CONTROLLER TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
