(1) Remove four nuts and wheel cover.
(2) Start engine (TM 9-2320-364-10).
(3) Set CTIS controller to HIGHWAY.
(4) Press CTIS START button.
(5) Check air lines at wheel hub to wheel
valve for air leakage.
(a) If air lines are damaged, crimped or
leaking, perform Step (6) below,
and tighten loose fittings, replace
air lines or fittings (Para 13-6).
(b) If there are no leaks, crimps or dam-
age, air lines and fittings are OK.
(6) Turn OFF ENGINE switch.
Wear safety goggles when performing leakage tests on valves. Failure to do so may result in serious
eye injury due to high pressure air.
Exercise extreme caution when working around wheels or under truck while engine is operating.
Movement of truck may cause injury or death to personnel.
Tires must be deflated to 60 psi (414 kPa)
or less to perform this test.