(1) Set multimeter select switch to ohms.
(2) Remove LHS control assy
(3) Is there continuity between LHS
NO TRANS lamp electrical connector
wire 1725 terminal and harness
connector MC83, terminal S?
(a) If there is no continuity, repair wire
1725 (see schematic Fig 2-52)
and perform Step (4) below
or notify DS Maintenance.
(b) If there is continuity, wire 1725
(4) Install LHS control assy (Para 7-40).
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.