| |
TM 9-2320-364-20-3
2-2327
Keep clear of equipment when equipment
is being raised or lowered. Equipment
may fall and cause serious injury or
death to personnel.
Remove all jewelry such as rings, dog
tags, bracelets, etc. If jewelry or
tools contact positive electrical circuits,
a direct short may result. Damage to
equipment, injury or death to personnel
may occur.
Never crawl under equipment when performing
maintenance unless equipment is securely
blocked. Equipment may fall and cause
serious injury or death to personnel.
Do not work on any item supported only
by lift jacks or hoist. Always use blocks
or proper stands to support the item prior
to any work. Equipment may fall and cause
injury or death to personnel.
Adhesive, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To
avoid injury or death, keep away from open
fire and use in a well-ventilated area. If
adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with
soap and water.
(1) Start engine (TM 9-2320-364-10).
(2) Set hydraulic selector switch to
AUTO position.
(3) Raise LHS until middle frame is
approximately 3 ft (91 cm) above
transit position.
(4) Turn OFF ENGINE switch.
(5) Set hydraulic selector switch to
OFF position.
(6) Block middle frame up in two places
securely.
(7) Set multimeter select switch to
ohms.
(8) Connect main junction box terminal
10 to a known good ground using
jumperwire.
Continued next page.
CONTINUITY TEST
|