(1) Disconnect harness connector MC93
from hydraulic selector switch
(2) Set multimeter selector switch to
(3) Is there continuity between harness
connector MC93, terminal C and
harness connector MC83, terminal B?
(a) If there is no continuity, repair wire
1481 (see schematic Fig 2-52) or
notify DS Maintenance.
(b) If there is continuity, wire 1481 is
(4) Install LHS control assembly
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.