| |
TM 9-2320-364-20-3
2-2474
15. LHS INOPERATIVE WITH INTERFACE KIT INSTALLED.
INITIAL SETUP
1.
Is the LED #2 lamp ON with the
engine switch ON and the hy-
draulic selector switch in
AUTO or MAN mode?
Go to Step 6 of
this Fault.
START
NO
No mission module hooked up
to interface quick disconnect.
LED #2 lamp is not ON.
Wire 1790 from LED #2 lamp to
connector MC135 terminal D
faulty.
Wire 1790 from connector
MC135 terminal D to connector
MC133 terminal 1 faulty.
Wire 1435 between connector
MC133 terminal 2 and
connector MC135 terminal E
faulty.
Wire 1435 between connector
MC135 terminal E and LED #2
lamp faulty.
LED #2 lamp faulty.
Wire 1790 between LED #2
lamp and relay R35 terminal 87
faulty.
Relay R35 faulty.
Wire 1734 between relay R35
terminal 30 and resistor faulty.
Resistor faulty.
Wire 1734 between resistor and
rectifier terminal AC faulty.
Wire 1734 between resistor and
connector MC135 terminal B
faulty.
Wire 1734 between connector
MC135 terminal B and
connector MC132 terminal 1
faulty.
Wire 1435 between connector
MC132 terminal 2 and
connector MC135 terminal C
faulty.
Wire 1435 between connector
MC135 terminal C and LED
#2 lamp faulty.
Wire 1435 between LED #2
lamp and relay R35 terminal 85
faulty.
Wire 1734 between relay R35
terminal 86 and resistor faulty.
KNOWN INFO
POSSIBLE PROBLEMS
TEST OPTIONS
REASON FOR QUESTION
Visual Inspection.
If LED #2 lamp is ON and LHS is
inoperative, power is present up
to LED #2 lamp.
2-28. LOAD HANDLING SYSTEM (LHS) TROUBLESHOOTING (CONT).
Tools and Special Tools
Tool Kit, General Mechanics: Automotive
(Item 74, Appendix G)
STE/ICE-R (optional) (Item 3, Appendix G)
Multimeter (Item 44, Appendix G)
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Parking brake applied, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
YES
WARNING
Read WARNING
on Page 2-2475
|