|
| |
TM 9-2320-364-20-3
2-2501
2
1
TERMINAL 2
CONNECTOR
MC132
M10 HARNESS
(1) Disconnect connector MC132 from
M10 harness.
(2) Set multimeter switch to OHMS.
(3) Is there continuity between wire 1435
connector MC132 terminal 2 and a
known good ground?
(a) If there is no continuity, repair wire
1435 (see schematic Fig 2-57)
or notify DS Maintenance.
(b) If there is continuity, perform Step (4)
below and go to Step 15 of this Fault.
(4) Connect connector MC132 to M10
harness.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
