(1) Disconnect remote control unit cable
from truck and remote control unit
(2) Set multimeter select switch to ohms.
(3) Is there continuity between cable
connector terminal G at both ends?
(a) If there is no continuity, replace
cable and perform Step (4) below.
Go to Step 9 of this Fault.
(b) If there is continuity, perform
Step (4) below and go to Step 6
of this Fault.
(4) Reconnect cable to truck hookup and
remote control unit hookup.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.