Quantcast CONTINUITY TEST - TM-9-2320-364-20-3_725

Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: CONTINUITY TEST
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
6.  BOOM WILL NOT TELESCOPE IN USING REMOTE CONTROL UNIT (CONT) - TM-9-2320-364-20-3_724
Up
TM-9-2320-364-20-3 Truck Tractor M1074 and M1075 Palletized Load System (PLS) Manual
Next
6.  BOOM WILL NOT TELESCOPE IN USING REMOTE CONTROL UNIT (CONT) - TM-9-2320-364-20-3_726
TM 9-2320-364-20-3      2-2603 (1)   Disconnect cable from remote control unit (TM 9-2320-364-10). (2)   Remove TELESCOPE controller from remote control unit (Para 18-4). (3)   Set multimeter select switch to ohms. (4)   Turn ON remote control unit ON/OFF EMERGENCY STOP switch. (5)   Is there continuity between remote control unit hookup, terminal H and four terminal connector, terminal 8B? (a)   If there is no continuity, repair wire 8 between switch and four terminal connector (see schematic Fig 2-58) or notify DS Maintenance. (b)   If there is continuity, go to Step (6) below. (6)   Is there continuity between remote control unit hookup, terminal B and four terminal connector, terminal 2C? (a)   If there is no continuity, repair wire 2 (see schematic Fig 2-58) or notify DS Maintenance. (b)   If there is continuity, go to Step (7) below. (7)   Is there continuity between remote control unit hookup, terminal C and four terminal connector, terminal 11? (a)   If there is no continuity, repair wire 11 (see schematic Fig 2-58) or notify DS Maintenance. (b)   If there is continuity, go to Step (8) below. (8)   Is there continuity between remote control unit hookup, terminal D and four terminal connector, terminal 12? (a)   If there is no continuity, repair wire 12 (see schematic Fig 2-58) or notify DS Maintenance. (b)   If there is continuity, go to Step 3 of this fault. CONTINUITY TEST Remove all jewelry such as rings, dog tags, bracelets, etc.  If jewelry or tools contact positive electrical circuits, a direct short may result.  Damage to equipment, injury or death to personnel may occur.

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc.