(1) Connect remote control unit to
remote control unit cable.
(2) Connect controller four terminal
connector to remote control unit
harness four terminal connector.
(3) Set multimeter select switch to
(4) Connect positive (+) multimeter
lead to white wire terminal in four
(5) Connect negative () multimeter
lead to a known good ground.
(6) Turn ON ENGINE switch
(7) Set hydraulic selector switch to
(8) Set crane POWER switch to
(9) Set remote control ON/OFF
EMERGENCY STOP power switch
to ON position.
(10) Hold TELESCOPE controller in the
(a) If 22 to 28 vdc are not present,
perform Step (11) below and
replace circuit card (Para 18-4).
(b) If 22 to 28 vdc are present,
perform Steps (11) and (12) below.
(11) Set the following switches to the
OFF position: remote control
ON/OFF EMERGENCY STOP
power switch, crane POWER
switch, hydraulic selector switch and
(12) Assemble remote control unit
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.