| |
TM 9-2320-364-20-3
2-2645
(1) Disconnect remote control unit cable
from truck and remote control unit
(TM 9-2320-364-10).
(2) Set multimeter select switch to ohms.
(3) Is there continuity between cable
connector terminal L at both ends?
(a) If there is no continuity, replace
cable.
(b) If there is continuity, connect
cable to truck hookup and remote
control unit hookup and go to
Step 6 of this Fault.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|