| |
TM 9-2320-364-20-3
2-2675
(1) Inspect all tubes around crane control
valve banks and hand pump.
(a) If tube is damaged, crimped or
leaking, tighten loose fitting or
replace tube (Para 20-3 and
schematic Fig 2-59 through 2-64).
(b) If tubes are not damaged,
crimped or leaking, go to Step (2).
(2) Inspect all hoses around crane control
valve banks.
(a) If hose is damaged, crimped or
leaking, tighten loose fitting or
replace hose (Para 20-3).
(b) If hoses are not leaking or
crimped, go to Step 3 of this Fault.
VISUAL INSPECTION
High pressure hydraulics [oil under 3,100 psi
(21,374 kPa) pressure] operate this equipment
Refer to vehicle operator and maintenance
manuals for hydraulic oil pressure. Never
disconnect any hydraulic line or fittings
without first dropping pressure to zero.
A high pressure oil stream can pierce body
and cause severe injury to personnel.
|