| |
TM 9-2320-364-20-3
2-2785
(1) Connect positive (+) multimeter lead
to diode at blue wire.
(2) Connect negative multimeter () lead
to a known good ground.
(3) Turn ON ENGINE switch
(TM 9-2320-364-10).
(4) Set crane POWER switch to ON
position.
(5) With the aid of an assistant, observe
multimeter while HIGH IDLE switch is
held in the LATCH position.
(a) If 22 to 28 vdc are not
present, perform Steps (6)
and (7) below and repair blue wire
(see schematic Fig 2-58) or notify
DS Maintenance.
(b) If 22 to 28 vdc are present,
perform Steps (6) and (7) below
and go to Step 7 of this Fault.
(6) Set crane POWER switch to OFF
position.
(7) Turn OFF ENGINE switch.
VOLTAGE TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|