(1) Set multimeter select switch to ohms.
(2) Is there continuity on wire 1435
between AUX HYD light connector
and a known good ground?
(a) If there is no continuity, repair wire
1435 (see schematic Fig 2-52) or
notify DS Maintenance. Perform
Step (3) below.
(b) If there is continuity, wire 1435
(3) Install AUX HYD light.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.