3-8. ENGINE OIL FILTER ADAPTER REPAIR (CONT).
Use care when removing springs.
Springs are under tension and
can act as projectiles when
released and could cause injury
Position adapter (1) in soft jawed vise.
Install valve disk (5), spring (4), retainer (2)
and screw (3) in adapter (1).
Remove adapter (1) from vise.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
Coat threads of two screws (4) with sealing
Position gasket (6) and engine oil filter adapter (3) on engine (7).
Install two lockwashers (5) and screws (4) in engine oil filter adapter (3). Tighten screws to 25 lb-ft (34
Coat threads of four screws (1) with sealing compound.
Install cushion clip (2) and four screws (1) on engine oil filter adapter (3). Tighten screws to 25 lb-ft (34
Install engine oil filter, (Para 3-6).
Install right fender front, (Para 17-33).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK