|
| |
TM 9-2320-364-20-4
7-15
(18)
Position three alternator belts (15) on
alternator (11) and engine pulley (16).
(19)
Install nut (5), lockwasher (13) and washer
(12) on alternator arm (6).
(20)
Position alternator support arm (6) in bracket
(14).
(21)
Tighten screw (37) to 170 lb-ft (23 N.m).
(22)
Position alternator support arm (6) on
alternator (11) with screw (10) and locknut
(9).
(23)
Position washer (8), lockwasher (7) and nut
(4) on alternator support arm (6).
(24)
Install belt tensioning gage on belts (15).
(25)
Tighten nut (5) on alternator support arm (6)
until alternator belts tension reaches 60 to 65
lbs (260 to 289 N).
(26)
Tighten nut (4) on alternator support arm (6).
(27)
Remove belt tensioning gage from belts (15).
(28)
Tighten locknut (9) on screw (10) to 26 to
30 lb-ft (30 to 41 N.m).
(29)
Tighten nut (1) on screw (2) and alternator
mounting bracket (3) to 90 lb-ft (122 N.m).
c.
Follow-On Maintenance:
Adjust alternator belts, (Para 7-5).
Install hydraulic drive shaft, (Para 20-2).
Install cab engine access panel, (Para 17-24).
Install left front noise panel, (Para 17-27).
Connect batteries, (Para 7-87).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
