| |
TM 9-2320-364-20-4
7-113
(4)
Remove and discard tape (8) from turn
signal wiring harness (2).
(5)
Remove turn signal switch arm (9) from
turn signal switch (10).
(6)
Remove mounting screws (11) and (12)
from turn signal switch (10) and emergency
hazard switch.
NOTE
Tag and mark electrical pins
before removing from electrical
connector.
(7)
Using terminal pin remover, remove six
contacts (14) and dust boots (15) from turn
signal connector MC7 (3).
(8)
Using terminal pin remover, remove
contacts (16) and dust boots (17) from turn
signal connector MC92 (5).
(9)
Remove and discard seven contacts (14)
and (16) and dust boots (15) and (16) from
turn signal wiring harness (2).
(10)
Remove turn signal wiring harness
sleeve (18) from turn signal wiring
harness (2).
(11)
Route turn signal wiring harness (2)
through steering column (19) while
removing turn signal switch (10) and
emergency hazard switch (13).
b.
Installation.
(1)
Route turn signal wiring harness (2) through
steering column (19) while installing turn
signal switch (10) and emergency hazard
switch (13).
|