| |
TM 9-2320-364-20-4
7-185
NOTE
There are five marker lights.
All marker lights are
assembled the same way.
Install cable ties as required.
Perform Steps (6) through (9)
for front marker light with
lamp.
Perform Steps (10) through
(13) for front marker light
with LED.
(6)
Install gasket (9), marker light assembly (5)
and two self-tapping screws (8) on marker
light bracket (10).
Corrosion inhibitor contains
alkali. Do not get in eyes; wear
goggles/safety glasses when
using. Avoid contact with skin. In
case of contact, immediately
wash area with soap and water. If
eyes are contacted, flush eyes
with large amounts of water for
at least 15 minutes and get
immediate medical attention.
(7)
Apply anti-corrosion silicone compound to
inside of lamp socket (7).
(8)
Install lamp (6) in lamp socket (7).
(9)
Install two screws (3) in lens cover (4).
(10)
Position ground wire (27) through hole in
marker light assembly (13).
(11)
Install LED (17) in marker light assembly
(13) and turn 1/4 turn clockwise.
(12)
Install gasket (15), marker light assembly
(13), ground wire (27) and two self-tapping
screws (14) on marker light bracket (16).
(13)
Install two screws (11) in lens cover (12).
7
11
17
27
13
14
16
15
12
|