7-55. HAND HELD WORK LAMP ASSEMBLY REPAIR (CONT).
Install hand held work lamp assembly (2) in
work light mounting bracket (3).
Adhesives, solvents and sealing
compounds can burn easily, can
give off harmful vapors and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
Apply primer and sealing compound on
three threads of connector (1).
Electrical harness must be routed
through clip until harness clears
Install connector (1) on hand held work
lamp assembly (2).
Connect batteries, (Para 7-87).
Check operation of work lamp assembly,
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK