|
| |
TM 9-2320-364-20-4
7-206
7-56.
DDEC II ENGINE COLD PLATE/ELECTRONIC CONTROL MODULE
(ECM) REPLACEMENT (CONT).
NOTE
Washers may or may not be
present in Step (9).
If mounts are damaged,
mounts and screws must be
replaced.
(9)
Remove four screws (21), washers (22),
eight mounts (23) and ECM (14) from ECM
mounting bracket (24).
NOTE
Perform Steps (10) through (15)
if removing ECM bracket.
(10)
Remove screw (25), lockwasher (26) and
washer (27) from ECM mounting
bracket (24). Discard lockwasher.
(11)
Remove screw (28), lockwasher (29) and
washer (30) from ECM mounting
bracket (24). Discard lockwasher.
(12)
Remove screw (31), lockwasher (32) and
washer (33) from ECM mounting
bracket (24). Discard lockwasher.
(13)
Remove screw (34), lockwasher (35),
washer (36) and turbo boost sensor
bracket (37) from ECM mounting
bracket (24). Discard lockwasher.
(14)
Remove screw (38), lockwasher (39),
washer (40) and turbo oil line clamp (41)
from ECM mounting bracket (24). Discard
lockwasher.
(15)
Remove ECM mounting bracket (24) from
engine (42).
|
