Type 1 Connector Repair.
Terminals come in different
styles and sizes. To prevent
damage, be sure to use only the
exact replacements. Do not
attempt to modify terminal to fit.
Repeat procedure as necessary.
Unscrew cover (1).
Slide plastic sleeve (2) back.
Remove wire (3) and terminal (4) from
Cut as close to damaged
terminal as possible.
Cut off terminal (4) at end of wire (3).
Remove insulation (6) ¼ inch (.635 cm)
from end of wire (3). Discard terminal.
Install terminal (4) on wire (3) and
crimp in place.
Install terminal (4) on connector (5).
Install sealing plugs (7) in unused
Slide plastic sleeve (2) against
Install cover (1) on connector (5).