14-9. GEAR BOX STEERING SHAFT REPAIR (CONT).
Rod end clevis and yoke end
cross and bearing assemblies
are removed the same way.
Rod end clevis shown.
Remove lube fitting (9) from cross and
bearing assembly (10).
Use care when removing
retaining rings. Retaining rings
are under spring tension and can
act as projectiles when released
and could cause severe eye injury.
Remove four retaining rings (11) from cross
and bearing assembly (10).
Use caution when removing
bearing assemblies. Needles in
bearing assemblies may become
lost or damaged.
Remove four bearing assemblies (12) from
steering shaft (1) and rod end clevis (13).
Remove rod end clevis (13) and cross and
bearing assembly (8) from steering shaft (1).
Repeat Steps (6) through (9) for yoke end
cross and bearing assembly removal.