Quantcast c. Cleaning/Inspection - TM-9-2320-364-20-5_120

Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: c. Cleaning/Inspection
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Needles in bearing assemblies
Up
TM-9-2320-364-20-5 Palletized Load System (PLS) M1074/M1075 Manual
Next
d. Assembly - TM-9-2320-364-20-5_121
TM 9-2320-364-20-5 14-32      14-10.  AXLE NO. 5 STEERING SHAFT REPAIR (CONT). c. Cleaning/Inspection. Drycleaning Solvent (P-D-680) is TOXIC and flammable.  Wear protective goggles, face shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors.  Keep away from heat or flame.  Never smoke when using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C).  Failure to do so may result in injury or death to personnel. If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help.  If solvent contacts skin or clothes, flush with cold water.  If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. (1) Clean all metal parts with drycleaning solvent. Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa).  Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.). Failure to comply may result in injury or death to personnel. (2) Dry all parts with compressed air. (3) Inspect steering shaft for cracks or dents. (4) Inspect universal joint for pitting and gouges. (5) Inspect bearing caps for cracks or missing needle bearings. (6) Inspect splines and dust cap for cracks. (7) Replace all damaged parts.

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc.