|
| |
TM 9-2320-364-20-5
17-59
NOTE
Perform Step (11) only if truck is
equipped with gas particulate kit.
If truck is not equipped with gas
particulate kit, go to Step (12).
(11) Disconnect C3 connector (25) and S19
connector (26) from gas particulate filter
rocker switch (27).
(12)
Disconnect C2 connector (28) and S10
connector (29) from winch in/out rocker
switch (30).
(13)
Disconnect C1 connector (31) and S4
connector (32) from winch/crane rocker
switch (33).
(14)
Disconnect 439 wire (34) and wire 1052
(35) from engine stop rocker switch (36).
(15)
Remove side panel (2) from truck and
position on clean work surface.
(16)
Loosen screw (37) and remove hydraulic
selector switch handle (38) from hydraulic
selector switch (39).
(17)
Remove hydraulic selector switch face
plate (40) from hydraulic selector
switch (39).
(18)
Remove four screws (41) and hydraulic
selector switch mounting plate (42) from
side panel (2).
|
