|
| |
TM 9-2320-364-20-5
17-60
17-20. ELECTRONIC CONTROL BOX (ECB) SIDE PANEL REPLACEMENT (CONT).
NOTE
Perform Steps (19) through (21)
if equipped with LHS Controller
Protection Kit.
(19)
Remove screw (43), locknut (44) and relay
(8) from side panel (2). Discard locknut.
(20)
Remove two nuts (45), fuse holders (6) and
seals (46) from front of side panel (2).
(21)
Remove two covers (47) and fuses (48)
from fuse holders (6).
(22)
Remove nut (49) and washer (50) from
panel light (14).
(23)
Remove panel light (14) from side panel
(2).
NOTE
There are seven rocker switches
and one pilot light housing. All
are removed the same way.
(24)
Push tab (51) on back of rocker switches
(36), (33), (30), (27), (24), (18) and (16)
and remove each switch from side panel (2).
(25)
Drill out rivets (52) from four data
plates (53), (54), (55) and (56) and
remove each data plate from side panel (2).
Discard rivets.
NOTE
Perform Step (26) if
equipped with LHS
Controller Protection Kit.
Perform Step (26) if data
plate is damaged.
(26)
Remove fuse data plate (57) from side panel (2).
b.
Installation.
NOTE
Perform Step (1) if equipped
with LHS Controller
Protection Kit.
Perform Step (1) if data plate
was removed.
(1)
Position fuse data plate (57) on side panel (2).
24
49
36
46
27
30
44
33
45
45
18
14
47
48
8
2
16
43
46
6
6
47
6
6
48
51
50
|
