|
| |
TM 9-2320-364-20-5
17-97
(4)
Install two braces (14) on rear fender (11)
using four screws (13) and locknuts (12).
(5)
Position rear fender (11) on fender support
arm (3).
(6)
Position screw (9), washer (8) and
locknut (7) in fender support arm (3) and
fender brace (10).
(7)
Install two screws (6) and locknuts (5) in
fender support arm (3).
(8)
Tighten locknut (7) on screw (9).
(9)
Install self-tapping screw (4) in fender
support arm (3).
NOTE
Push clips are properly installed
when lock button is pushed in
after installation.
(10)
Install marker lamp wiring harness (2) and
six push clips (1) on fender support arm (3).
d.
Follow-On Maintenance:
Install rear fender reflector, (Para 19-2).
Install rear fender side marker lamp, (Para 7-48).
Install center mud flap, (Para 17-38).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
