|
| |
TM 9-2320-364-20-5
17-112
Materials/Parts
Locknut (4) (Item 133, Appendix F)
Washer (AR) (Item 347, Appendix F)
This task covers:
a. Alignment
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Engine Off (TM 9-2320-364-10)
Wheels Chocked (TM 9-2320-364-10)
Tools and Special Tools
Tool Kit, General Mechanics: Automotive
(Item 74, Appendix G)
Hammer, Hand, Soft Plastic
(Item 33, Appendix G)
Socket Set 3/8 in. (Item 62, Appendix G)
17-41. CAB SEAT LOCK ALIGNMENT PROCEDURE.
a.
Alignment.
(1)
Push seat lock lever (1) towards drivers cab door to release seat lock. Move seat forward or backward.
NOTE
If seat locks upon release of seat lock lever (1) alignment is not needed.
If seat does not lock upon release of seat lock lever (1). Perform Steps (3) through (9).
(2)
Release seat lock lever (1).
(3)
Remove four locknuts (2), from two screws (3) and screws (4). Discard locknuts.
(4)
Using a soft faced hammer, tap the front of seat support (5).
|
