|
| |
TM 9-2320-364-20-5
21-122
21-27. CONTAINER HANDLING UNIT (CHU) LIGHT BAR AND BRACKETS
ASSEMBLY REPAIR (CONT).
(10)
Position ground wire (23) through hole in
marker light assembly (18).
(11)
Install LED (26) in marker light assembly
(18) and turn 1/4 turn clockwise.
(12)
Install gasket (24), marker light assembly
(18), two screws (22), ground wire (23),
ground wire (21), wire 489 (20) and two
locknuts (19) on marker light bracket (25).
(13)
Install lens cover (17) with two screws (16)
on marker light assembly (18).
Corrosion inhibitor contains
alkali. Do not get in eyes; wear
goggles/safety glasses when
using. Avoid contact with skin.
In case of contact, immediately
wash area with soap and water. If
eyes are contacted, flush eyes
with large amounts of water for at
least 15 minutes and get
immediate medical attention.
(14)
Apply corrosive preventive compound to
ground wire (21).
(15)
Connect wire 1012 (5) to wire 489 (3).
(16)
Install push clip (2) and two wires 489 (3)
on rear marker light assembly (4).
(17)
Connect MC90 connector (1).
f.
Follow-On Maintenance:
Connect batteries, (Para 7-87).
Check operation of rear marker light
assembly, (TM 9-2320-364-10).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
2
3
4
5
3
16
17
18
19
20
22
23
24
25
26
21
1
|
