Position lifting frame (3) in stow mode
With the aid of an assistant, position lifting
frame (3) using LHS, approximately 6 in.
(15 cm) before slot in flipper bracket (4)
engages with rotary paddle (1).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a
well-ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
Shaft of air cylinder is loosened
and tightened by using wrench on
flats near clevis.
Loosen shaft (5) on air cylinder (6) and
apply sealing compound to threads.
Tighten shaft (5) on air cylinder (6) and
clevis (7) until rotary paddle (1) aligns with
slot in flipper bracket (4).
Stow lifting frame (3) on truck and check
operation of flipper bracket (4) (TM
Repeat Steps (6) through (10) as necessary.
Position lifting frame on truck in container mode, (TM 9-2320-364-10).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK