Remove eight screws (23) and washers (24)
from cylinder head (3).
Attach lifting tees and chain to cylinder
Cylinder head weighs 182 lbs
(83 kg). Attach suitable lifting
device prior to removal to
prevent possible injury to
Attach lifting device to chain.
Remove remaining two screws (23) and
washers (24) from cylinder head (3).
When positioning cylinder head
on work bench, support valve
side of cylinder head on two in.
(51 mm) wooden blocks to
prevent damage to cam
With the aid of an assistant, remove cylinder
head (3) from engine block (25) and position
on wooden blocks.
Remove lifting tees and chain from cylinder
Remove and discard seal strip gasket (26),
16 water seals (27), oil seal (28) and four
compression gaskets (29) from engine
Note position and location of
shims prior to removal.
Remove two support shims from engine
block (25). Discard shims.