|
| |
TM 9-2320-364-34-2
3-89
(2)
Install pulley drive shaft (15) on
camshaft (46) with three lockwashers (45)
and screws (44). Tighten screws to 15 to 19
lb-ft (20 to 26 N.m).
(3)
Apply coat of grease to gasket (42) and
install on front balance cover (6).
Ensure oil seal is fully seated
upon installation of front
balance cover. Failure to comply
may result in damage to
equipment or oil leakage.
(4)
Install front balance cover (6) on end
plate (43).
(5)
Install three washers (40), screws (39),
lockwashers (41) and nuts (38) in front
balance cover (6). Tighten nuts to 30 to 35
lb-ft (41 to 47 N.m).
(6)
Install screw (35), washer (37),
lockwasher (36) and locknut (34) in front
balance cover (6). Tighten locknut to 35 to
39 lb-ft (47 to 53 N.m).
(7)
(7) Install screw (31), lockwasher (32),
washer (33) and locknut (30) in front
balance cover (6). Tighten locknut to 35 to
39 lb-ft (47 to 53 N.m).
|
