|
| |
TM 9-2320-364-34-2
4-25
(37)
Install crossover tube (27) on left thermostat
housing (29) and right thermostat
housing (28).
(38)
Position rubber tube (26) on crossover
tube (27) and left thermostat housing (29).
(39)
Position rubber tube (26) on crossover
tube (27) and right thermostat housing (28).
(40)
Position four clamps (25) over rubber
tubes (26) and tighten 40 lb-in (5 N.m).
(41)
Install two lockwashers (9), washers (10),
screws (8) and cushion clips (11) on rear of
engine (12) and wiring harness (13). Tighten
screw 23 lb-ft (31 N.m).
Ensure clamp is properly
positioned around seal prior to
Step (50). Failure to comply
may result in leakage of seal.
(42)
Tighten clamp (6) on blower drive
support (4) until clamp is completely
compressed.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(43)
Apply sealing compound to threads of adapter (3).
(44)
Install adapter (3) on blower drive support (4).
(45)
Tighten nut (2) on adapter (1).
(46)
Connect tachometer drive connector (7) at rear of blower (5).
c.
Follow-On Maintenance:
Install air inlet housing, (Para 4-3).
Install air compressor, (Para 10-4).
Install engine cold plate and ECM, (TM 9-2320-364-20).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
