|
| |
TM 9-2320-364-34-2
5-31
b.
Installation.
(1)
Position fan drive motor (4) in vise with soft
jaws.
(2)
Install fan motor plate (3) on fan drive
motor (4) with four screws (17) and
locknuts (16). Tighten nuts to 80 lb-ft
(108 N.m).
(3)
Position key (15) in fan motor shaft (13).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(4)
Apply antiseize compound to fan motor
shaft (13).
NOTE
Fan clutch hub is installed with
wide shoulder facing downward.
(5)
Position fan clutch hub (14) on fan motor
shaft (13).
(6)
Install washer (12) and nut (11) on fan
motor shaft (13). Tighten nut 209 lb-ft
(283 N.m).
(7)
Tighten nut (11) on fan motor shaft (13)
until slot in nut (10) aligns with hole in fan
motor shaft (13).
(8)
Install cotter pin (10) in fan motor shaft (13)
and nut (10).
|
